GE Vivid 4 BT03 RFI - Hard Disk Replacement Procedure; Hard Disk Removal Procedure; Preparation; Tools

GE MEDICAL SYSTEMS
D
IRECTION 2392751-100, REVISION 3VIVID™ 4 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-81
8-5-16 Hard Disk Replacement Procedure
8-5-16-1 Tools
Use the appropriate flat and Phillips-type screw drivers and a wire cutter as indicated in the Hard Disk
replacement procedure.
8-5-16-2 Preparation
Shut down the Vivid™ 4 ultrasound unit, as described in Chapter 3 - Installation.
8-5-16-3 Hard Disk Removal Procedure
1) Remove the left cover, as described Side Covers Removal Procedure section, page 8-4.
2.) Remove the BEP side cover as described in the BEP2 - Side Cover Removal Procedure on page
8 - 54.
3.) Remove the screw that holds the hard disk module in position (as shown in Figure 8-56 below).
4) Carefully slide the module out from the unit.
5) Remove each of the four screws (two on each side), as shown in Figure 8-67 on page 8-82.
Figure 8-66 Hard Disk Removal 1