GE MEDICAL SYSTEMS
D
IRECTION 2392751-100, REVISION 3VIVID™ 4 SERVICE MANUAL
8-122 Section 8-8 - Peripherals
8-8-2-4-1 Mitsubishi VCR Setup Procedure
NOTE: This procedure must be performed on initial Mitsubishi VCR installation.
NOTE: The Mitsubishi VCR can be configured using the Menus on the front panel (Figure 8-110) as follows:
•Use the Jog button to navigate between the selections.
• Push the Enter button to apply your selection.
To configure the Mitsubishi VCR:
1.) Press the VCR Play B. button on the Vivid™ 3 control console to display the VCR menus on the
Vivid™ 3 monitor.
2.) Using the Jog button on the VCR front panel (Figure 8-110), select the required VCR menu
language (Figure 8-111), then press the Enter button to continue to the next menu.
3.) Select the <Menu1> settings, according to the configuration shown in Figure 8-112 below , then
press the Enter button to continue to the next menu.
Figure 8-110 Mitsubishi VCR Front Panel
Figure 8-111 Language Menu
Jog Button
Enter Button
To Next Page
Loading...
