GE MEDICAL SYSTEMS
D
IRECTION 2392751-100, REVISION 3VIVID™ 4 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-57
8-5-4 Plug & Scan Board Replacement Procedure
8-5-4-1 Tools
Use the appropriate flat and Phillips-type screw drivers and a wire cutter, as indicated in the Plug & Scan
board replacement procedure.
8-5-4-2 Preparation
Shut down the Vivid™ 4 ultrasound unit, as described in Chapter 3 - Installation. Voltage may exist in
the system when a Plug & Scan is present. Ensure that a full shutdown of the system is performed,
otherwise voltage might be present that can cause injury and/or damage.
8-5-4-3 Plug & Scan Board Removal Procedure
1) Remove the machine’s rear and left and right side covers, as described in Side Covers Removal
Procedure on page 8 - 4 and Rear Cover Removal Procedure on page 8 - 7.
2) Disconnect the power cable from the rear of the BEP.
3) Remove the BEP side cover, as described in the BEP2 - Side Cover Removal Procedure on page
8 - 54.
4) If applicable, remove the octopus card holder as described in the BEP2 - Octopus Card Holder
Removal Procedure on page 8 - 56.
5) Disconnect all cables connected to the Plug & Scan board from the keyboard control card, the
battery and the power supply.
Note: Counting from the top, the board is positioned in the first PCI slot.
6) Release the securing screw located on the left of the board bracket.
7) Gently remove the Plug & Scan board from the BEP.
8-5-4-4 Plug & Scan Board Installation Procedure
1) Gently insert the Plug & Scan board into its slot.
Note: Counting from the top, the board is positioned in the first PCI slot.
2) Fasten the board with the screw on the left of the bracket.
3) Reconnect the cables to the Plug & Scan board from the keyboard control card, the battery and the
power supply.
4.) If applicable, mount the octopus card holder as described in the BEP2 - Octopus Card Holder
Installation Procedure on page 8 - 56
5) Mount the BEP side cover as described in the BEP2 - Side Cover Installation Procedure on page 8
- 54.
6) Reconnect the power cable to the rear of the BEP.
7) Install the Vivid™ 4 rear, and left and right side covers, as described in the Side Covers Installation
Procedure on page 8 - 4, and the Rear Cover Installation Procedure on page 8 - 7.
Note: Perform a complete functional check of the Plug & Scan, as described in Chapter 4 -
Functional Checks.
To Next Page
Loading...
