GE Vivid 4 BT03 RFI - CDRW Drive Installation Procedure

GE MEDICAL SYSTEMS
D
IRECTION 2392751-100, REVISION 3VIVID™ 4 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-67
8-5-11-4 CDRW Drive Installation Procedure
Note: Before installing the new CDRW Drive, make sure the jumper settings closest to the data
cable are shorted as follows:
1) For BEP2:
Use the metal slides provided with the CDRW drive, or use those from the drive previously
removed.
2) Carefully slide the CDRW Drive into the front of the BEP (refer to Figure 8-51 on page 8-66).
3) Reconnect the cables (data and power) to the rear of the CDRW Drive.
4) Install the BEP left and right side covers, as described in the BEP2 - Side Cover Installation
Procedure on page 8 - 54.
5.) Reconnect the power cable to the rear of the BEP.
6) Return the Vivid™ 4 rear, left and right covers - see the Side Covers Installation Procedure on page
8 - 4 and Rear Cover Replacement Procedures on page 8 - 7.
Data cable
Power cable
MasterSlave