GE Vivid 4 BT03 RFI - BEP2 - Front Cover Installation Procedure; BEP2 - Octopus Card Holder Installation Procedure; BEP2 - Octopus Card Holder Removal Procedure

GE MEDICAL SYSTEMS
D
IRECTION 2392751-100, REVISION 3VIVID™ 4 SERVICE MANUAL
8-56 Section 8-5 - Back End Parts Replacement
8-5-3-6 BEP2 - Front Cover Installation Procedure
1) Return the front cover to the front of the BEP and press the two latches on the side, in order to push
the cover back into position.
2) Replace and tighten the two screws to secure the BEP front cover in position - see Figure 8-45 on
page 8-55.
8-5-3-7 BEP2 - Octopus Card Holder Removal Procedure
1) Remove the three screws that secure the Octopus Card Holder in position as shown in Figure 8-47
below.
2.) Remove the Octopus Card Holder.
8-5-3-8 BEP2 - Octopus Card Holder Installation Procedure
1) Place the Octopus Card Holder in position on the BEP part, holding it firmly in place.
2) Return the three screws and tighten them to hold the Octopus Card Holder securely in position, as
shown in Figure 8-47, above.
Figure 8-47 Octopus Card Holder - BEP2
Octopus Card Holder