GE MEDICAL SYSTEMS
D
IRECTION 2392751-100, REVISION 3VIVID™ 4 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-45
Section 8-5
Back End Parts Replacement
Replacement of internal Back End Processor components should be done by qualified personnel only.
When replacing internal BEP components, ensure replacement is with new components of the same
type, and hardware version and place them in the PCI slots as shown in the appropriate figure below.
Refer to Figure 8-39 or Figure 8-40, as appropriate.
CAUTION: Failure to follow this exact instruction will cause irreversible damage!
8-5-1 Preparation
Furnished Materials
Confirm that the Back End Processor Kit (P/N: 2315842-7) contains the following items:
Important: The BEP arrives inside packing box P/N 2328455. Make sure the returned BEP is
shipped for return in the same packing box.
P/N Description Quantity
2406742 Backend (BEP) Assembly 1
2330026 BEP Front Panel for MOD 1
2344553 BEP Front Panel Basic 1
2344630 BEP Upper bracket 1
2343032 MO Drive Track 2
2399332 BEP Installation Instructions. 1
2347549-3 CD with SW VER 2.3.11 1
2419774 CD VGA Upgrade Patch 1
2413447 CD Patch 2.3.12 1
2413448 CDRW Patch 1
2400730 CD Probe Overheating Protection Patch 1
2418083 CD with SW VER 3.3 1
2418084 CD with SW VER 4.3 1
2418086 CD with SW VER 3.6 1
2418087 CD with SW VER 4.6 1
2366934 Help Files CD 1
2412393 CD Pouch Assy 1
To Next Page
Loading...
