GE MEDICAL SYSTEMS
D
IRECTION 2392751-100, REVISION 3VIVID™ 4 SERVICE MANUAL
3-28 Section 3-5 - Completing the Hardware Installation
Note: All the color printer cables are located in the left storage compartment under the metal cover.
3) After connecting the remaining peripherals and switching the system ON, configure the printer
settings, as described in the Printers Tab section, on page 3-44.
For more details about peripherals installation, refer to Chapter 8 - Replacement Procedures - see the
Peripherals section, on page -114.
3-5-2-5 Connecting the HP DeskJet 6122 Color Printer
Note: If there is sufficient space, the HP DeskJet 6122 Color Printer may be installed under the
control console. Alternatively, it will require a suitable stand or table to be positioned in
close proximity to the Vivid™ 4 scanner - at a distance of not more than 1m (3.3 ft) from the
power connection to the Vivid™ 4 unit.
WARNING: Whenever moving the Vivid™ 4 scanner, the DeskJet Color Printer must be
disconnected from the scanner. DO NOT attempt to move the two units simultaneously without
first disconnecting them. After relocation, re-connect the printer to the scanner.
1) Place the DeskJet color printer on the shelf below the control console (or alternatively on the
designated stand or table, adjacent to the unit).
2) Connect the following cables as shown in Tab l e 3-14:
3) After connecting the remaining peripherals and switching the system ON, configure the printer
settings, as described in the Printers Tab section, on page 3-44.
For more details about peripherals installation refer to Chapter 8 - Replacement Procedures - see the
Peripherals section, on page -114.
Table 3-13 Color Printer Cables
From the Color Printer
To the Cables
underneath the Control Console
Video IN R, G, B, Sync
External Trigger Print Trigger
AC IN AC Power Cable
Table 3-14 DeskJet Color Printer Cables
From the Color Printer To the Right Panel
Parallel Port Connector Parallel Port
AC IN (AC Dual Power cable) Panel AC outlet
To Next Page
Loading...
