Genban IP8820 - Troubleshooting Guide

IP8820/IP8830/IP8840
Installer Guide
104
Jan 17 4:32
Subnet Mask
255.255.255.0
Clear OK

Jan 17 4:32
Default Gateway
192.168.0.1
Clear OK

 Press the
digit, or move the cursor to 2.WIFI Configuration using [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 1.Profile using [Next]-[Previous] softkeys and
press the [OK] softkey.
 Press the
digit, or move the cursor to 6.Subnet Mask using [Next]-[Previous]
softkeys and press the [OK] softkey.
 Input the Subnet Mask using the dial pad and press
the [OK] softkey to save your entry.
 Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration
session.
5.3.1.7 Default Gateway
Selecting static addressing for the Network mode requires manual entry of a default gateway
address for the WiFi Module. The WiFi Module requires a valid default gateway address for
proper operation.
To assign the Default Gateway address:
 Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
 Press the
digit, or move the cursor to 1.Network Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 2.WIFI Configuration using [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 1.Profile using [Next]-[Previous] softkeys and
press the [OK] softkey.
 Press the
digit, or move the cursor to 7.Default Gateway using [Next]-[Previous]
softkeys and press the [OK] softkey.
 Input the Default Gateway using the dial pad and
press the [OK] softkey to save your entry.
 Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration
session.
The Default Gateway address can be changed only in static mode and not if DHCP
mode is active. In DHCP mode, the IP phone retrieves a default gateway address from
the DHCP server.
Changing the Default Gateway address requires a reboot of the IP phone; when you
leave the menu, you will receive a reboot notice. The IP phone must reboot to utilize
the new values entered.