Genban IP8820 - Username

IP8820/IP8830/IP8840
Installer Guide
48
Jan 17 4:32
Provisioning URL
update.pes.com
Mode OK

Jan 17 4:32
Username
admin
Mode OK

 Press the digit, or move the cursor to 3.HTTPS Provisioning using the [Next]-
[Previous] softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 1.Provisioning URL using the [Next]-
[Previous] softkeys and press the [OK] softkey.
 Input the provisioning server URL using the dial
pad and press the [OK] softkey to save the entry.
 Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration session.
Changing the provisioning server URL requires a reboot of the IP Phone; when you
leave the menu, you will receive a reboot notice. The IP Phone must reboot to utilize
the new values entered.
To enter alphanumeric characters select the [Mode] softkey. Refer to Appendix E
for
the character mapping of dial pad digits.
3.6.7.3.2 Username
In some cases, the HTTP/HTTPS server requires a Username
(Id) and Password for
authentication prior to allowing file access.
To set the Username:
 Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
 Press the
digit, or move the cursor to 3.Phone Settings using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 7.S/W Update using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 3.HTTPS Provisioning using the [Next]-
[Previous] softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 2.Username using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Input the Username using the dial pad, and press
the [OK] softkey to save your entry.
 Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration session.
Changing the Username requires a reboot of the IP Phone; when you leave the menu,
you will receive a reboot notice. The IP Phone must reboot to utilize the new values
entered.
To enter alphanumeric characters select the [Mode] softkey. Refer to Appendix E
for
the character mapping of dial pad digits.