IP8820/IP8830/IP8840
Installer Guide
34
Jan 17 4:32
Backup Proxy Address
100.1.1.1
Mode OK
Jan 17 4:32
Backup Proxy Port
5060
Clear OK
Press the Settings ( ) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
Press the
digit, or move the cursor to 2.SIP Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
Press the
digit, or move the cursor to 4.Backup Proxy Address using the [Next]-
[Previous] softkeys and press the [OK] softkey.
Input the Backup Proxy Address using the dial pad
and press the [OK] softkey to save your entry.
Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration
session.
Changing the Backup Proxy Address requires a reboot of the IP Phone; when you leave
the menu, you will receive a reboot notice. The IP Phone must reboot to utilize the new
values entered.
To enter alphanumeric characters select the [Mode] softkey. Refer to Appendix E
for
the character mapping of dial pad digits.
3.5.2.4 Backup Proxy Port
The Backup Proxy Port defines the port used when sending SIP messages to the backup proxy
defined under section 3.5.2.3
.
To assign the Backup Proxy Port:
Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
Press the
digit, or move the cursor to 2.SIP Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
Press the
digit, or move the cursor to 5.Backup Proxy Port using the Next]-
[Previous] softkeys and press the [OK] softkey.
Input the Backup Proxy Port using the dial pad and
press the [OK] softkey to save your entry.
Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration
session.
Changing the Backup Proxy Port requires a reboot of the IP Phone; when you leave the
menu, you will receive a reboot notice. The IP Phone must reboot to utilize the new
values entered.
To Next Page
Loading...