Genban IP8820 - Vlan ID (Lan); VLAN Priority (LAN)

IP8820/IP8830/IP8840
Installer Guide
22
Jan 17 4:32
VLAN Priority (LAN)[0-7}
0
Clear OK

For proper operation, other network elements (LAN switches and default gateway) must
support and be configured with proper VLAN parameters.
VLAN settings are overwritten if CDP is enabled.
Changing the VLAN parameters requires a reboot of the IP phone; when you leave the
menu, you will receive a reboot notice. The IP phone must reboot to utilize the new
values entered.
3.4.8.1 VLAN Priority (LAN)
The VLAN Priority (LAN) establishes the priority for Ethernet frames from the IP8820, IP8830
and IP8840 voice port including signaling and voice packets. Setting the VLAN ID to zero (0)
disables VLAN framing and the IP Phone uses only standard Ethernet frames.
To assign VLAN Priority for the LAN (voice) port:
 Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
 Press the
digit, or move the cursor to 1.Network Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 8.VLAN Settings using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 1.VLAN Priority (LAN) using the [Next]-
[Previous] softkeys and press the [OK] softkey.
 Input the VLAN Priority for the LAN port using the
dial pad and press the [OK] softkey to save your
entry.
 Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration session.
Changing the VLAN Priority requires a reboot of the IP Phone; when you leave the
menu, you will receive a reboot notice. The IP Phone must reboot to utilize the new
values entered.
The recommended value for VLAN Priority (LAN) port is 5.
To disable VLANs, assign the VLAN ID as zero (0).
3.4.8.2 VLAN ID (LAN)
The VLAN ID (LAN) assigns the identification for Ethernet frames for the IP Phone voice port
including signaling and voice payloads. Setting the VLAN ID to zero (0) disables the VLAN
framing and the IP Phone uses only standard Ethernet frames.
To assign the VLAN ID for the LAN (voice) port:
 Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.