K
Settings ( ) button to exit the configuration session.
The IP address can be changed only in static mode and not if DHCP mode is active. In
DHCP mode, the IP phone retrieves an IP address from the DHCP server.
Changing the IP Address requires a reboot of the IP phone; when you leave the menu,
you will receive a reboot notice. The IP phone must reboot to utilize the new values
entered.
3.4.3 Subnet Mask
Selecting static addressing for the Network mode requires manual entry of a subnet mask for
the IP phone. The IP phone requires a valid subnet for proper operation.
To enter the Subnet Mask:
Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
Press the
digit, or move the cursor to 1.Network Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
Press the
digit, or move the cursor to 3.Subnet Mask using the [Next]-[Previous]
softkeys and press the [OK] softkey.
Input the Subnet Mask using the dial pad and press
the [OK] softkey to save your configuration.
Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration
session.
The Subnet Mask can be changed only in static mode and not if DHCP mode is active.
In DHCP mode, the IP phone retrieves a subnet mask from the DHCP server.
Changing the Subnet Mask requires a reboot of the IP phone; when you leave the
menu, you will receive a reboot notice. The IP phone must reboot to utilize the new
values entered.
3.4.4 Default Gateway
Selecting static addressing for the Network mode requires manual entry of a default gateway
address for the IP phone. The IP phone requires a valid default gateway address for proper
operation.
To assign the Default Gateway address:
Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
Press the
digit, or move the cursor to 1.Network Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
To Next Page
Loading...