Genban IP8820 - Phone Settings

IP8820/IP8830/IP8840
Installer Guide
31
Jan 17 4:32
Line Type
*Private Line
Next OK
Previous
Jan 17 4:32
Enter DN
5559992
Mode OK

 Press the digit, or move the cursor to 1.Line Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
 Enter the line button number or move the cursor using the [Next]-[Previous] softkeys and
press the [OK] softkey to select a line button.
 Press the
digit, or move the cursor to 8.Line Type using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Select the type for the line using the [Next]-
[Previous] softkeys and press the [OK] softkey to
save your entry.
 Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration session.
Changing the Line Type requires a reboot of the IP Phone; when you leave the menu,
you will receive a Reboot notice. The IP Phone must reboot to utilize the new values
entered.
An asterisk, , is displayed in front of the current selection.
3.5.1.9 MADN Directory Number
A shared line requires entry of the associated DN (Directory Number). Note assign a DN only
for a shared line type.
To assign the DN for a shared line,
 Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
 Press the
digit, or move the cursor to 2.SIP Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 1.Line Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
 Enter the line button number or move the cursor using the [Next]-[Previous] softkeys and
press the [OK] softkey to select a line button.
 Press the
digit, or move the cursor to 9.Directory Number using [Next]-[Previous]
softkeys and press the [OK] softkey.
 Input the Directory Number for the shared line
using the dial pad and press the [OK] softkey to
save your entry.
 Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration session.
Assign a Directory Number only for a shared line. Do not assign a Directory Number for
a private line.