Genban IP8820 - Call Waiting; Call Waiting Tone

IP8820/IP8830/IP8840
Installer Guide
58
Jan 17 4:32
Do Not Disturb
Current value is ‘Yes’
Next No
Yes
Jan 17 4:32
Call Waiting
Current value is ‘Yes’
Next No
Yes
 Press the digit, or move the cursor to 1.Do Not Disturb using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the [Yes] softkey to enable DND, or press
the [No] softkey to disable DND.
 Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration session.
3.7.2 Call Waiting
With Call Waiting configured, while on a call the IP Phone alerts the user of an incoming call.
The line button flashes to indicate the new call, and an optional beep tone is delivered over the
existing conversation, see section 3.7.3
. In addition, the LCD displays the incoming caller id
during the ring signal so you know who is calling before you interrupt the current call.
If Call Waiting is disabled, the IP Phone will reject the new call. The call server configuration
determines routing of the incoming call.
To enable/disable Call Waiting:
 Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
 Press the
digit, or move the cursor to 4.Call Preferences using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 2.Call Waiting using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the [Yes] softkey to enable Call Waiting, or
press the [No] softkey to disable Call Waiting.
 Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration session.
3.7.3 Call Waiting Tone
While off-hook, the IP Phone can provide a tone over the existing conversation to indicate a call
waiting. To receive the tone Call Waiting must also be enabled. Refer to section 3.7.2
.
To enable/disable Call Waiting Tone:
 Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
 Press the
digit, or move the cursor to 4.Call Preferences using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 3.Call Waiting Tone using the [Next]-
[Previous] softkeys and press the [OK] softkey.