IP8820/IP8830/IP8840
Installer Guide
37
Jan 17 4:32
VMS Address
100.1.1.1
Mode OK
Jan 17 4:32
Domain
genband.com
Mode OK
Press the Settings ( ) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
Press the
digit, or move the cursor to 2.SIP Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
Press the digits
, or move the cursor to 10.VMS Address using the [Next]-
[Previous] softkeys and press the [OK] softkey to save your entry.
Input the VMS Address using the dial pad and
press the [OK] softkey to save your entry.
Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration session.
To enter alphanumeric characters select the [Mode] softkey. Refer to Appendix E
for
the character mapping of dial pad digits.
3.5.2.10 Domain
The Domain specifies the domain for SIP service when the provider desires to use a specific
SIP domain for the IP Phone.
To assign the Domain
Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
Press the
digit, or move the cursor to 2.SIP Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
Press the digits
, or move the cursor to 11.Domain using the [Next]-[Previous]
softkeys and press the [OK] softkey.
Input the Domain name using the dial pad and
press the [OK] softkey to save your entry.
Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration session.
To enter alphanumeric characters select the [Mode] softkey. Refer to Appendix E
for
the character mapping of dial pad digits.
3.5.2.11 STUN Server
When the phone is located behind NAT and a STUN server exists, this menu sets the STUN
server IP address or FQDN.
To assign the STUN server
Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
To Next Page
Loading...