Genban IP8820 - IP8830 and IP8840 Bluetooth Support; Pairing a Bluetooth Headset

IP8820/IP8830/IP8840
Installer Guide
54
Jan 17 4:32
Key Tone
Current value is ‘Yes’
Next No
Yes
Jan 17 4:32
Paired Headset List
*Wireless Headset(00:1A:12:34:56:78)
Next Delete
A
dd
To enable/disable the Key Tone:
 Press the Settings (
) button.
 Press the
digit, or move the cursor to 3.Phone Settings using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the
digits, or move the cursor to 10.Key Tone using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the [Yes] softkey to enable the Key Tone, or
press the [No] softkey to disable the Key Tone.
 Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration session.
3.6.11 IP8830 and IP8840 Bluetooth Support
The IP8830 and IP8840 can be equipped with a Bluetooth module allowing use of a headset
that supports Bluetooth connections in place of a wired headset, see section 2.4
for installation
details. Prior to using a Bluetooth headset, it must be paired and can then be connected with
the Bluetooth module. This section describes how to pair, connect, disconnect and delete a
Bluetooth headset. Note that the Bluetooth menu is only available when a Bluetooth module is
installed in the IP phone
An asterisk, , displays in front of the current headset selection
When the Bluetooth module is installed, the icon
is displayed in upper part of the
IP8830 or IP8840 LCD. When one or more, maximum five (5), Bluetooth headsets are
paired, the icon
is displayed and when connected, the icon is displayed.
When a Bluetooth headset is connected, a wired headset cannot be used and the
Headset button will control the Bluetooth headset.
3.6.11.1 Pairing a Bluetooth headset
A Bluetooth headset must be paired with the IP8830 and IP8840 Bluetooth module before it can
be connected (activated). Up to five (5) headsets may be paired with the IP Phone at one time.
To Pair and connect a new headset with the IP Phone:
 Press the Settings (
) button.
 Press the
digit, or move the cursor to 3.Phone Settings using the [Next]-[Previous]
softkeys, and press the [OK] softkey.
 Press the
digits, or move the cursor to 11.Bluetooth using the [Next]-[Previous]
softkeys, and press the [OK] softkey.
 Press the
digit, or move the cursor to
1.Headset Management using the [Next]-
[Previous] softkeys, and press the [OK] softkey.
This will display a list of previously paired headsets.