IP8820/IP8830/IP8840
Installer Guide
64
Jan 17 4:32
Will be set to default
Are you sure?
Next No
Yes
Jan 17 4:32
Phone Book (Page 1)
>(15) Sammy, 5555556
Next Dial
Previous
Jan 17 4:32
Calling to 15/20
5555556
EndCall Dial
Previous
Press the digit, or move the cursor to 5.Directory using the [Next]-[Previous]
softkeys and press the [OK] softkey.
Press the
digit, or move the cursor to 1.Phone Book using the [Next]-[Previous]
softkeys and press the [OK] softkey.
Select a contact to dial using the [Next]-[Previous] softkeys.
Press the [Dial] softkey to place the call.
To dial a contact using the Down navigation or a Phone
Book flexible button, see section 3.6.5
:
Press the Down navigation button or Phone Book flexible button while the IP Phone is idle.
Select a contact to dial using the [Next]-[Previous] softkeys,
Press the [Dial] softkey to place the call.
3.9 Default
The IP Phone configuration can be returned to the original factory defaults, see Appendix A.
To return to the default configuration:
Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
Press the
button, or move the cursor to 6.Default using the [Next]-[Previous]
softkeys, and press the [OK] softkey.
Press the [Yes] softkey to set the IP Phone to the
default configuration, or press the [No] softkey to
cancel.
Move to another parameter with the navigation
buttons and continue the session or press the Settings (
) button to exit the
configuration session.
Returning the configuration to default requires a reboot of the IP Phone; when you leave
the menu, you will receive a reboot notice. The IP Phone must reboot to utilize the new
values entered.
Returning the IP Phone to the default configuration deletes all previous customized
settings.
3.10 Reboot
After changing certain parameters, the IP Phone will require a reboot to utilize the settings.
These settings include the following:
- Network Configuration settings
To Next Page
Loading...