IP8820/IP8830/IP8840
Installer Guide
27
Jan 17 4:32
Enter Display Name
Richard
Mode OK
Settings ( ) button to exit the configuration session.
Changing the Proxy Port requires a reboot of the IP Phone; when you leave the menu,
you will receive a reboot notice. The IP Phone must reboot to utilize the new values
entered.
3.5.1.3 Display Name
When assigned, the Display Name is used in SIP headers as the caller id name.
To enter the Display Name:
Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
Press the
digit, or move the cursor to 2.SIP Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
Press the
digit, or move the cursor to 1.Line Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
Enter the line button number or move the cursor using the [Next]-[Previous] softkeys and
press the [OK] softkey to select a line button.
Press the
digit, or move the cursor to 3.Display Name using the [Next]-[Previous]
softkeys and press the [OK] softkey.
Input the Display Name using the dial pad and
press the [OK] softkey to save your entry.
Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration
session.
To enter alphanumeric characters select the [Mode] softkey. Refer to Appendix E
for
the character mapping of dial pad digits.
3.5.1.4 Name
The Name is used in SIP headers as the SIP user id or account assigned in the call server. A
name is required for proper operation and must match the user id or account assigned in the
call server.
To enter the Name:
Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
Press the
digit, or move the cursor to 2.SIP Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
Press the
digit, or move the cursor to 1.Line Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
To Next Page
Loading...