Genban IP8820 - Delayed Ring

IP8820/IP8830/IP8840
Installer Guide
40
Jan 17 4:32
Ring Type (1)
*Type 3
Next OK
Play
Jan 17 4:32
Delayed Ring Timer (6)
0
Clear OK

 Press the Settings ( ) button.
 Press the
digit, or move the cursor to 3.Phone Settings using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 2.Ring Setting using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Dial the line number plus one (2 for Line 1, 3 for Line 2, etc.), or move the cursor to Line n
Configuration using the [Next]-[Previous] softkeys and press the [OK] softkey. The
value of n is the line button number.
 Select the Ring Type using the [Next] softkey.
Press the [Play] softkey to hear the selected tone.
The Ringer Off selection turns the ringer off for
incoming calls on the line. The “Set as Default”
uses the Default Ring Type for incoming calls on the line, see section 3.6.6.1
.
 Press the [OK] softkey to save the selection.
 Move to another parameter with the navigation buttons and continue the session or press
the Settings (
) button to exit the configuration session.
If no Ring Type or “Set as Default” is assigned for a line, the “Default Ring Type” is
used.
The Line Ring Type can be set to any of the 14 Ring types, “Set as Default” or “Ringer
Off”. When set as Ringer Off, the phone will not ring for incoming calls on the line.
For Ring Type, an asterisk, , displays in front of the current selection
3.6.2.3 Delayed Ring
To set delayed ring for a line:
 Press the Settings (
) button.
 Press the
digit, or move the cursor to 3.Phone Settings using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 2.Ring Setting using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Dial the line number plus one (2 for Line 1, 3 for Line 2, etc.), or move the cursor to Line n
Configuration using the [Next]-[Previous]
softkeys and press the [OK] softkey. The value of
n is the line button number.
 Enter the delay time as 0 to 10 seconds in 1-
second increments. A zero (0) provides no delay; the ring signal is immediate.
 Press the [OK] softkey to save to the delayed ring setting.
 Move to another parameter with the navigation buttons and continue the session or press
the Settings (
) button to exit the configuration session.