IP8820/IP8830/IP8840
Installer Guide
24
Jan 17 4:32
VLAN ID (PC)[0-4094]
0
Clear OK
3.4.8.4 VLAN ID (PC)
The VLAN ID (PC) assigns the identification for Ethernet frames for the IP Phone PC port.
Setting VLAN ID to zero (0) disables VLAN framing and the IP Phone uses only standard
Ethernet frames.
To assign the VLAN ID (PC) port:
Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
Press the
digit, or move the cursor to 1.Network Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
Press the
digit, or move the cursor to 8.VLAN Settings using the [Next]-[Previous]
softkeys and press the [OK] softkey.
Press the
button, or move the cursor to 4.VLAN ID (PC) using the [Next]-[Previous]
softkeys and press the [OK] softkey.
Input the VLAN ID (PC) port using the dial pad and
press the [OK] softkey to save your entry.
Move to another parameter with the navigation
buttons and continue the session, or press the
Settings (
) button to exit the configuration session.
Changing the VLAN ID (PC) port requires a reboot of the IP Phone; when you leave the
menu, you will receive a reboot notice. The IP Phone must reboot to utilize the new
values entered.
To disable VLANs, assign the VLAN ID as zero (0).
3.4.9 CDP
IP Phones can be assigned to employ the Cisco
®
Discovery Protocol to determine if VLANs are
to be used and the associated VLAN Id. The CDP selection displays only if ‘function_cdp’ is
enabled in the configuration file, see Appendix D
. As a default, the CDP selection displays.
To set the CDP status when ‘function_cdp’ is enabled:
Press the Settings (
) button. If the LCD Menu is locked, use the unlock procedure.
Refer to section 3.3
.
Press the
digit, or move the cursor to 1.Network Configuration using the [Next]-
[Previous] softkeys and press the [OK] softkey.
Press the
digit, or move the cursor to 9.CDP using the [Next]-[Previous] softkeys and
press the [OK] softkey.
To Next Page
Loading...