Genban IP8820 - Ring Setting; Default Ring Type; Line Ring Type

IP8820/IP8830/IP8840
Installer Guide
39
Jan 17 4:32
LCD Contrast
□□□□
Up OK
Down
Jan 17 4:32
Default Ring Type
*Type 1
Next OK
Play
 Press the [Down] softkey to decrease the contrast,
or press the [Up] softkey to increase the contrast.
 Move to another parameter with the navigation
buttons and continue the session or press the
Settings (
) button to exit the configuration session.
3.6.2 Ring Setting
The IP Phone uses one of 14 ring signals (Ring Types) or no ring (“Ringer Off”) for incoming call
notification. Each line and Phone Book record may have a different ring type assigned including
“Ringer Off” and “Set as Default”. A “Default Ring Type” is defined, which is used when a ring
type is “Set as Default” or not defined for a line or Phone Book record.
For each line, the ring signal can be immediate or delayed by up to 10 seconds. Delayed ring is
defined in one-second increments from 0 to 10 seconds. By assigning different ring signals to
closely located phones lines or Phone Book records, the user can identify the ringing phone,
line or caller.
Ring types 1 through 4 and 101 to 105 are fixed in the IP Phone memory and may be selected
by the user. An additional five tones, Ring Type 201 to 205, use an RTTTL format text file,
which must be downloaded to the IP Phone prior to selection. Refer to _Appendix G
for
additional details on RTTTL ring tones.
3.6.2.1 Default Ring Type
To select the Default Ring Type (tone) for the IP Phone:
 Press the Settings (
) button.
 Press the
digit, or move the cursor to 3.Phone Settings using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 2.Ring Setting using the [Next]-[Previous]
softkeys and press the [OK] softkey.
 Press the
digit, or move the cursor to 1.Default Ring Type using the [Next]-
[Previous] softkeys and press the [OK] softkey.
 Select the Ring Type using the [Next] softkey. Press
the [Play] softkey to hear the selected tone.
 Press the [OK] softkey to change to the selected
Ring Type.
 Move to another parameter with the navigation buttons and continue the session or press
the Settings (
) button to exit the configuration session.
3.6.2.2 Line Ring Type
To adjust the Ring type (tone) for a line: