Genban IP8820 - Network Configuration

IP8820/IP8830/IP8840
Installer Guide
10
Phone, make sure the LAN and power connections are disconnected from the phone, see
section 2.1
.
To install the Bluetooth module:
 Disconnect the IP Phone from power and the LAN.
 Remove cover from the option module slot behind and below LCD.
 Insert the Bluetooth module in the slot.
 Reconnect to LAN and power.
Figure 2.4-1 Bluetooth Module Installation
2.5 WiFi Module Installation
The IP8830 and IP8840 phones can be equipped with an optional WiFi module to allow
connection to a wireless WiFi network. The WiFi Module is installed in the slot below and
behind the LCD as shown in Figure 2.5-1. When installed, Network Configuration of the WiFi
module is accomplished as described in section 5
.
To install the WiFi module:
 Disconnect the IP Phone from power and the LAN.
 Remove cover from the option module slot behind and below LCD.
 Insert the WiFi module in the slot.
 Reconnect to power.
Figure 2.5-1 WiFi Module Installation