IP8820/IP8830/IP8840
Installer Guide
A-1
Appendix A. Factory Default Configuration
Factory default configurations are settings for the configuration, which are set at the factory.
Table A-1
below gives the default values for configurable parameters.
Table A-1 Default Configuration
Config File
Section Name
Parameter/Field Default Value
Network Type Wired
Network mode DHCP
IP address 192.168.1.1
Subnet mask 255.255.255.0
Default gateway 192.168.1.254
Primary DNS address 0.0.0.0
Secondary DNS address 0.0.0.0
TFTP server address Not assigned
ToS (Type of Service)* 0
PC port VLAN priority 3
PC port VLAN id 0
LAN port VLAN priority 5
LAN port VLAN id 0
[LAN]
CDP enabled
Network Mode DHCP
IP address 192.168.1.1
Subnet mask 255.255.255.0
Default gateway 192.168.1.254
Primary DNS address 0.0.0.0
Secondary DNS address 0.0.0.0
SSID Null
Security Mode Not assigned
WiFi
Security Key Null
Call server address line 1 0.0.0.0
Proxy port line 1 5060
Display name line 1 Not assigned
Name line 1 Not assigned
Auth. user name line 1 Not assigned
Auth. password line 1 Not assigned
Line 1 line type Private
Directory Number line 1 Not assigned
Line 1 DSS Extension Not assigned
Ring Type for line 1 default ring
Delayed ring for line 1 0 seconds
Call server address line 2 0.0.0.0
Proxy port line 2 5060
Display name line 2 Not assigned
[VOIP]
Name line 2 Not assigned
To Next Page
Loading...