3-62
Chapter 3 Settings and Measurement
Contents General Description
Checks and Preparation
Settings and Measurement
Example of Use Specification
(4)-8 How to specify the channel to copy alarm settings
1. Copy the settings on the ALARM tab.
2. Select the source CH. The source CH will be marked with a “*” mark.
If you clear the selection, the currently selected CH will be cleared and you will return to the previous screen.
3. Specify the copy destination. The copy destination CH will be marked with a “>” mark.
You can specify multiple copy destinations, and specifying a CH again will remove it from the copy destination.
Only copyable CHs can be selected.
4. Execute the copy.
To Next Page
Loading...
