15 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
Meaning of the warnings
Battery
must be
charged !!
Transmitter voltage too low
BIND?
OK
Bind?
No receiver is bound to the actually active model memory. By
tapping the ENT button you can accede the related option.
CAN‘T
RECEIVE
ANY DATA
OK
No bound receiver in range.
RF ON/OFF?
OFF
ON
Should the RF transmission be switched "ON" or "OFF"?
It appears only after switching the transmitter on with already
bound receiver in active model memory.
SWITCH
RF
OFF
OK
Request to switch the RF transmission off
Fail-Safe
setting!
Fail Safe setting not performed yet
T h r ottle
too
high!
Throttle or pitch control stick position or throttle limit for helicop-
ters too high
No
pupil
Signal
Connection between teacher and pupil transmitter disturbed
Switch-on warning
is active!!!
The transmitter has not been used within the last 10 minutes. In the
display it appears the warning, the red Graupner logo LED blinks and
an acoustic signal is emitted. If the transmitter is still not being used
it will autonomously switch off after about three minutes.
Impossible now
low voltage
In case of too low battery voltage a model change is not possible
for safety reasons. In the display appears a related message:
Please select
Trainer mode?
ON OFF
Should the "Wireless Teacher/pupil connection" used before the
last switch off of the transmitter be continued (CONTINUE) or
interrupted (INTERRUPT)?
To Next Page
Loading...
Need help?
General