82 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
TRIM value.
LIMIT–/+ (side-dependent limit -/+)
This option is for adjusting a side-dependent limit of the servo travel
(rudder deflection) of the servo connected to the control channel
selected in the "OUTPUT CH" line.
An adjustment within 30 … 150% is performed separately for both
directions.
Factory setting: 150%.
PERIOD (cycle time)
In this line, specify the periods for the individual channel pulses. This
setting is transferred for all control channels.
If your system is used exclusively with digital servos, you can set a
cycle time (frame rate) of 10 ms.
If your system includes some or uses exclusively analogue servos,
always select 20 ms since the analogue servos may be overloaded
and respond by "jittering" or "growling".
RX FAIL SAFE
The easiest and most recommendable way to make fail safe settings
is to use the "Fail-Safe" menu that can be reached from the multi
function list menu.
Furthermore, although a bit more involved, the "FAIL SAFE ALL"
option described on the next page also works.
Beyond this is the relatively complex method of individual adjust-
ments within the "RX FAIL SAFE" menu of the "Telemetry" menu
using the options "MODE", "F.S.Pos." and "DELAY". The description
of these versions starts with the "MODE" option below.
Value Description Possible settings
Vx.xx Firmware
version of the
receiver
None
OUTPUT
CH
Output channel
(servo connec-
tion of the
receiver)
1 … depending on the receiver
INPUT CH Input channel
(control channel
coming from
the transmitter)
1 … 16
RX FAIL SAFE V6.37
INPUT CH: 01
MODE : HOLD
F.S.Pos. : 1500µsec
DELAY : 0.75sec
OUTPUT CH: 01
FAIL SAFE ALL: NO
POSITION : 1500µsec
To Next Page
Loading...
