33 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
Phase setting (Air, land and water models)
Push the ENT key to recall the setting page of this menu.
Push the ESC key to stop the procedure.
As long as no switch is assigned to phase 2 or phase 3, the transmit-
the «normal» phase is not displayed as phase 1, but remains hidden.
It should also be pointed out that the phases are preceded by prior-
-
ment of individual switches. The underlying scheme can be described
as follows:
• If all the phase switches that are assigned are closed or open, the
• If only one switch is closed, then the phase which is assigned to
"Phase 2" is preceded by the phase name "Start" and "Phase 3" by
-
lows:
Programming the phase name step-by-step
1. Select the desired value field using the selection keys.
2. Push the ENT key.
3. Select a suitable phase name among the ones appearing in the
list.
4. Press the ENT key to complete the operation.
As soon as at least one switch is activated in the right column, the
name of the respective active phase is displayed in the basic display
as well as in all menus where phase settings are adjustable and all
phase-dependent settings made in the respective active phase are
active.
Model type
Phase setting
Phase trim
=>
=>
=>
=>
=>
Phase 2
Phase 3
Start
Speed
–––
–––
To Next Page
Loading...
Need help?
General