74 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
Programming step-by-step
1. Use the selection keys to select the desired line.
2. Assign the desired switch in the line upon the switch symbol "
".
3. Use the right selection key to switch to the right-hand column.
4. Push the ENT key.
5. Use the selection keys to select the desired announce.
6. Press the ENT key to complete the operation.
7. Proceed appropriately with the remaining lines.
8. Leave the menu pushing the ESC key.
Info display
Push the ENT key to recall the selection menu from the base display.
Select the desired menu with the selection buttons, then press the
ENT button again to recall the setting list of the menu.
Push the ESC key to stop the procedure.
In this menu, transmitter-specific information is displayed and it is
possible to reset the transmitter to the delivery state.
RFID
The RFID of the transmitter is displayed in this line. This ID is specific
for each transmitter, is only issued once per transmitter, and cannot
be changed.
Firmware version
The current version number of the transmitter software is displayed
in this line.
The version number could be required for service inquiries.
1
2
3
4
Announce file
–––
–––
–––
–––
–––
5
Trainer
Fail-
Safe
General
setting
Free
Mixer
An-
nounce
Info
display
RFID
Firmware version
Default setting
1.234
FA-AA-AA-A9-9F
=>
To Next Page
Loading...
Need help?
General