37 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
Note
A switching threshold of more than +100% is achieved by temporar-
ily increasing the path on the plus side of servo 1 in the "Servo
adjustment" menu to more than 100% and returning it to the orig-
inal value after storing the switching threshold.
Min.thr. min
Note
The settings of this option are effective only if a switch is assigned
in the line "M-Stop" and this is open.
Depending on the choice "yes" or "no" in the right value field of the
line "Min.thr. min", the default motor-off point can be moved in the
range of ±50% with the% value on the left. Thus, for example, a cer-
tain minimum rotational speed of the rotors can be set for the
descent. At the same time, the shifted point is the new zero point for
the CH1 trim.
Programming step-by-step
1. Push the ENT key.
2. Set the desired %-value.
3. Push the ENT key.
4. Use the selection keys to switch to the right setting field.
5. Push the ENT key.
6. Use "yes" to activate this option, "no" to deactivate it.
7. Push the ENT key.
Timers
To the right of the basic display there are two clocks: a stopwatch
and a flight or travel timer.
The stopwatch can optionally be forward or reverse. A reverse run-
ning stopwatch triggers acoustic signals from the transmitter in the
last 30 seconds.
The flight or the drive timer always start together with the stopwatch
but it continues to run when the stopwatch is stopped with the
assigned switch. The flight or drive timer can only be stopped by
pressing the ESC key when the stopwatch is stopped.
Pushing the left and the right selection buttons will reset the stopped
timers to the default value.
Programming step-by-step
1. Push the ENT key.
2. Use the selection buttons to set the desired number of minutes.
Timers
M.Stop
4:00
1
Race Timer =>
Min.Thr. min
+150%
yes
+5%
---
STO
–100%
M-01
0:32h
Stop
Flight
K78
0:00
0:00
5.5V
4.0V
NR
0.0V
Timers
M.Stop
4:00
1
Race Timer =>
Min.Thr. min
+150%
yes
+5%
---
STO
–100%
To Next Page
Loading...
Need help?
General