62 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
Programming the phase name step-by-step
1. Select the desired value field using the selection keys.
2. Push the ENT key.
3. Select a suitable phase name among the ones appearing in the
list.
4. Press the ENT key to complete the operation.
As soon as at least one switch is activated in the right column, the
name of the respective active phase is displayed in the basic display
as well as in all menus where phase settings are adjustable and all
phase-dependent settings made in the respective active phase are
active.
Phase trim (copter)
Push the ENT key to recall the setting page of this menu.
Push the ESC key to stop the procedure.
In this menu, you can enter the phase-dependent Nick control posi-
tion.
Setting the trim value step-by-step
1. Use the phase switch to switch to the desired phase.
2. Push the ENT key.
3. Use the selection keys to set the desired Nick value.
4. Push the ENT key.
5. Leave the setting menu for the selection list pushing the ESC key.
Phase setting
Phase trim
Phasentrimmung
=>
=>
=>
=>
=>
PHASE TRIM
normal
0%
NIC
Start
Speed
0%
0%
To Next Page
Loading...
Need help?
General