45 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
Transmitter setting
Select the desired menu using the selection buttons and then press
the ENT button to enter the setup page of the menu.
Push the ESC key to stop the procedure.
In this menu, the model-dependent basic settings of the transmitter
are defined.
System menu - Control mode
There are four different ways of assigning the four basic control func-
tions of both sticks. The options that are chosen depend on the indi-
vidual preferences of the model pilot.
Programming step-by-step
1. Push the ENT key.
2. Set the desired control mode through the selection keys.
3. Push the ENT key.
The possible control modes for the individual model types are:
Airplane
MODE 2 (throttle left)
elevator
elevator
rudder
rudder
full throttle
idle
aileron
aileron
full throttle
idle
rudder
rudder
elevator
elevator
aileron
aileron
elevator
elevator
aileron
aileron
full throttle
idle
rudder
rudder
full throttle
idle
aileron
aileron
elevator
elevator
rudder
rudder
MODE 1 (throttle right)
MODE 3 (throttle right)
MODE 4 (throttle left)
Helicopter
MODE 2 (throttle left)
Nick
Nick
tail rotor
tail rotor
Motor / Pitch
Motor / Pitch
Roll
Roll
Motor / Pitch
Motor / Pitch
tail rotor
tail rotor
Nick
Nick
Roll
Roll
Nick
Nick
Roll
Roll
Motor / Pitch
Motor / Pitch
tail rotor
tail rotor
Motor / Pitch
Motor / Pitch
Roll
Roll
Nick
Nick
tail rotor
tail rotor
MODE 1 (throttle right)
MODE 3 (throttle right)
MODE 4 (throttle left)
Model
memory
Wing
mix
M.Type
Phase
Servo
setting
Ctl
setting
D/R
Expo
Tx
setting
C1
curve
Control mode
1
–––
Timers 0:00
Rcv output
Bind
–––
Range test
99s
To Next Page
Loading...
Need help?
General