35 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
Phase trim (airplane)
Push the ENT key to recall the setting page of this menu.
Push the ESC key to stop the procedure.
In this menu the phase-dependent positions of the control surfaces
are entered. Depending on the settings made in the line "Aile./flap"
of the "Model type" menu, it is available in this menu with only one
"AI" and a maximum of three columns with "EL", "AI" and "FL".
Setting the trim value step-by-step
1. Use the phase switch to switch to the desired phase.
2. Move to the desired column with the selection keys.
3. Push the ENT key.
4. Use the selection buttons to set the desired control surfaces posi-
tion.
5. Push the ENT key.
6. The remaining options have to be dealt with appropriately.
Motor OFF+timer
Select the desired menu using the selection buttons and then press
the ENT button to enter the setup page of the menu.
Push the ESC key to stop the procedure.
Thr.HOLD
With the help of this option, the throttle/pitch (CH1) channel is
brought into a certain position after a switch has been actuated and
held in this position. The motor can then no longer start, no matter
in which position the throttle/pitch stick or the trim are.
The speed controller of the copter only assume the set position after
a switch has been activated and a specific switching threshold is
undershot.
The throttle-cut or idle position is specified in the left-hand column
and must be determined by tests.
In the middle column, the desired switching threshold is set and a
suitable ON / OFF switch is selected in the right column.
Activate the Throttle-cut function
• If the current servo position is below the switching threshold
specified in the middle column, the switchover takes place as
soon as the switch is moved to the ON position.
Model type
Phase setting
Phase trim
=>
=>
=>
=>
=>
PHASE TRIM
normal
0%
0%
0%
EL AIFL
Start
Speed
0%
0%
0%
0%
0%
0%
Model
memory
D/R
Expo
Tx
setting
Ctl
setting
Channel
setting
Phase
M.OFF
Timers
C1
curve
+
Timers
M.Stop
4:00
---
Race Timer =>
Min.Thr. min
+150%
–100%
yes
+6%
---
STO
To Next Page
Loading...
Need help?
General