55 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
C1 => FL
When the brake control function (C1 control stick) is actuated, both
flap control servos can be individually adjusted for the landing
between ±150% of the mixing ratio, usually downwards.
The value is normally selected so that when the brake control func-
tion is activated, the flaps move downwards as far as possible. Make
sure, however, that the servos concerned do not run into the
mechanical end point. Eventually, limit accordingly the servo travel
with the "LIMIT - / +" option found on the "RX SERVO" menu of the
"Telemetry" menu.
C1 => AI
With this mixer, in case of actuation of the brake control function
during the landing, both aileron servos are adjusted in the range of
±150% , usually upwards.
EL => FL
To support the elevator in tight curves and aerobatics, the flap func-
tion can be included by controlling the elevator with this mixer.
Select the mixing direction so that the flaps move downward when
the elevator is pulled (up), and conversely upward when the elevator
is pushed (down), that is, in an opposite direction.
The adjustment range is ±150%.
EL => AI
With this mixer you can support the elevator effect similar to the
previous mixer.
The adjustment range is ±150%.
FL => EL
When setting flaps, upward or downward torque can arise about the
transverse axis. It may also be desirable for the model to pick up the
pace somewhat when slightly elevating the flaps. Both of these reac-
tions can be achieved with the mixer.
When setting the flaps, you can use this mixer to have the position
of the aileron automatically track the flaps depending on the set
value.
The adjustment range is ±150%.
oder
oder
To Next Page
Loading...
Need help?
General