69 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
Fail-Safe
Push the ENT key to recall the selection menu from the base display.
Select the desired menu with the selection buttons, then press the
ENT button again to recall the setting list of the menu.
Push the ESC key to stop the procedure.
The "Fail Safe" function determines the response of the receiver
both by directly switching on the receiver system and when there is
an interruption in transmission from the transmitter to receiver.
The RC components connected to the receiver outputs 1 to max. 12
can then ...
• ... after the receiver is powered on and until there is no valid sig-
nal from the transmitter, take the positions saved in the receiver.
Completely independently from receiver settings "hold" or "pos".
• ... in case of interference ...
- ... ("HOLD").
In case of transmission interruptions, all RC components pro-
grammed to "hold" remain at their position which was last
identified to be correct until a new, correct control signal is
received by the receiver.
- ... after expiry of the preselected "delay time", move to the
positions ("Pos") previously stored in the receiver.
Note
The standard setting, until a change occurs, is the central position.
Fail-Safe setting step-by-step
1. Use one of the selection buttons to select one of the control chan-
nels to be changed from "Hold" to "Pos", or vice versa.
2. Push the ENT key.
The symbolic switch changes the page accordingly.
3. Proceed in the same way with the remaining channels.
4. Switch to the value field "Delay" at the lower edge of the display
with one of the selection keys.
5. Push the ENT key.
6. Use the selection keys to select the suitable delay time.
The following selections are available: 0,25, 0,5, 0,75 and 1 sec-
ond
7. Push the ENT key.
Trainer
Fail-
Safe
General
setting
Free
Mixer
An-
nounce
Info
display
FAIL-SAFE
Pos.
hold
1 2 3
4
5
6
Delay: 0 .2 5 s STO
To Next Page
Loading...
Need help?
General