Hammond SKX - Working with Patches

121
Save the Setup
WORKING WITH PATCHES
Save or Load the Patches to/from the USB Flash drive in the PATCH mode, not
SETUP mode on last page.
To locate this mode:
HOW TO READ THE DISPLAY
SAVING THE PATCH
To locate the PATCH mode, please refer to the illustration
above, “To locate this mode”.
WHAT DOES THIS MEAN?
USB is not ready.
USB Flash drive is not correctly inserted.
Select the “New File” by pressing the [] button (or turning
the [VALUE] knob) a few times.
Press the [ENTER] button to save your Patch.
WHAT DOES THIS MEAN?
Same name exists.
The USB Flash drive already contains a file by that name.
Modify the Patch name on the SKX, or delete the  le with
same name on the USB Flash drive (next page).
 e Patch name is automatically given as the  le name.
MENU/
EXIT
ENTER
Choose the Patch which you wish to save.
① INSERT THE USB FLASH DRIVE
Make sure that the USB Flash drive is correctly inserted.
② SELECT THE PATCH
③ LOCATE THE PATCH FILE MODE
④ SELECT “NEW FILE”
⑤ PRESS [ENTER] TO DECIDE
⑥ COMPLETED
PATCH name
This indicates another PATCH
 le above or below the current
one.
Type of File
PA: patch
What you are going to operate
This indicates there is another
page on the right (or on the left).