Skx
Owner’s Manual
78
GLIDE
⓫ GLIDE - RANGE (P)
Sets the pitch-bend range by semitone. Setting range is -24 to +12.
⓬ GLIDE - ATTACK TIME (P)
Sets the amount of time for the Glide e ect to reach the pitch set at (11). e setting
range is 0.1 to 5.0 seconds.
⓭ GLIDE - RELEASE TIME (P)
Sets the amount of time to return to normal pitch when the Glide is released.
⓮ GLIDE - AMP (P)
Engages a “fade” along with the Glide, where the volume drops in tandem with the
pitch to total silence.
⓯ GLIDE - DRAWBARS (P)
⓰ GLIDE - EXTRA VOICE 1 (P)
⓱ GLIDE - EXTRA VOICE 2 (P)
Assigns the Glide to the various sections of SKX. (15) is for Organ section, and (16)
and (17) are for the Extra Voice section.
DAMPER
⓲ DAMPER - UPPER (G)
⓳ DAMPER - LOWER (G)
⓴ DAMPER - PEDAL (G)
DAMPER - EXTRA VOICE 1 (G)
DAMPER - EXTRA VOICE 2 (G)
Assigns the Damper function to the various divisions of the SKX.
(18), (19) and (20) are for setting each part of the Organ section, and (21) and (22)
are for the Extra Voice section.
ASSIGN
OCTAVE BUTTON - DOWN (G)
OCTAVE BUTTON - UP (G)
OCTAVE BUTTON - LOWER (G)
Used to assign extra functions other than the original ones to the [OCTAVE] but-
DAMPER
Or “Sustain” pedal-analogous to the RIGHT pedal
on a piano. Sounds are held when this pedal is
depressed. Called “Damper” due to the fact that
when the pedal was depressed on a piano, the
mechanism that muted or “damped” the strings
was raised, allowing the piano strings to ring free.
CONTROL - continued
GLIDE
Since there is no pitch-bend function on the
B-3/C-3, some musicians would get a pitch-bend
e ect by quickly turning the power to the organ
“OFF” then “ON”.
If the RUN switch on a B-3/C-3 is turned o , the
Tone Wheel motor gradually slows down and
stops, and the ampli er turns o as well. You can
replicate this e ect using this function.
The SKX has added some parameters for Extra
Voice section to use as a simple pitch bend.
When Glide range is set at “-1”.
❶
❷
❸
❹
❺
❻
❼
❽
❾
❿
⓬
⓭
⓲
⓳
⓴
⓫
⓮
⓯
⓰
⓱
❺
To Next Page
Loading...
