Skx
Owner’s Manual
88
PIPE
In this mode, you edit the characteristics of each Pipe Stop.
To locate this mode:
See “Function mode” (P. 66) for operation details.
❶ PIPE STOP
Select the Pipe Stop which you desire to edit using [],[] buttons, or move the
Drawbar which corresponding the Pipe Stop.
ere are 20 Pipe Stops which according to Drawbars from “Bourdon 16´” to “Prin-
cipal Chorus + Mixture IV” (P. 46).
❷ VOLUME (Pi)
Adjusts the volume of the Pipe Stop. e setting range is 0 to 127.
❸ DETUNE (Pi)
Detunes the pitch of Pipe Stop from accurate pitch by cents ( of semitones).
e setting range is -50 - 0 - +50.
❹ CHIFF (Pi)
Sets the “ Chi ” noise of beginning of notes.
OFF: No chi .
SOFT: Soft chi .
MID: Moderate amount of chi .
LOUD: Maximum amount of chi .
NOTE: The Reed Pipes (Hautbois 8´ and Trompette 8´) are not a ected by this parameter.
❺ CUT OFF FREQUENCY (Pi)
Adjusts the tone quality of the Pipe Stop.
e setting range is -64 to 0. At 0, the full range of sound will be heard. Decreasing
this value will cause tone to become more mellow.
❻ PAN - DIRECTION (Pi)
Adjusts the directionality of the Pipes in order to simulate chamber placement.
e setting range is L64 - C - R63 (Left - Center - Right).
DETUNE
The beating is heard by sounding detuned pitch
on sounding accurate pitch.
Generally, they are effect works well if the low-
er-pitched Pipes are set a “-” value while higher-
pitched Pipes are set a “+” value. However, it is
strongly recommended that this effect be used
sparingly in order to avoid an unpleasant “out-of-
tune” e ect.
MENU/
EXIT
ENTER
❶
❷
❸
❹
❺
❻
❼
... omitted ...
To Next Page
Loading...
