Skx
Owner’s Manual
134
TROUBLESHOOTING
Malfunction of the buttons, the keys, etc.
Turn the POWER to instrument “OFF”, then turn it “ON”
again. If this procedure is not successful, turn “OFF” the
POWER switch. While pressing the [RECORD] button, turn
the [POWER] switch “ON” again. (Note that in this case, all
parameters return to their factory-preset status.)
No sound is produced when the keys are pressed.
e MASTER VOLUME is at the minimum setting.
Adjust the volume with the MASTER VOLUME control.
e [UPPER ON] [LOWER ON] buttons are OFF.
Press the button to switch ON.
e [ORGAN VOLUME] [EXTRA VOICE VOLUME] are
set at minimum.
Turn the knobs to adjust the volume of each section.
MIDI Local Control is OFF.
Turn the local control ON, if not using an external sequencer
or computer. (P. 112)
A Leslie speaker is connected via Leslie receptacle.
Line Out and Phones jack do not carry the audio output the
sound of Rotary channel (Organ section) when a Leslie speak-
er is connected.
Certain notes appear not to be playing.
Only L/MONO is connected, but Audio Mode is set to
“STEREO”.
Set the Audio Mode at “MONO”. (P. 102)
No change in Expression.
e Expression Source assignment is not correctly set.
Correctly set the Expression Source item in the CONTROL
mode. (P. 128)
e Expression mode of Overdrive is set at “OD Only” or
“Input”.
Set the Expression mode at except “OD Only” or “Input”. (P.
90)
e Source of Multi-E ect is set at “EXP”.
Set the Source at a parameter other than “EXP”. (P. 91)
e “EXP” (Expression) parameter for the Extra Voice section
at “OFF”.
Set the value at “ON”. (P. 75)
The Foot Switch does not work properly.
e Foot Switch assignment is not correctly set.
Correctly set the Foot Switch in the CONTROL mode. (P. 76)
The Foot Switch or Damper Pedal are working “back-
wards” - the function is enabled when switch is released
instead of depressed.
Misjudged the Foot Switch or Damper Pedal by connecting
their during power is “ON”
Connect the Foot Switch and/or Damper Pedal, then turn the
power to the SKX “ON”. e polarity of the switch(es) will be
set automatically. Do not depress the switch(es) until the SKX
is fully powered up: i.e., the PLAY mode screen is displayed.
The sound is interrupted brie y when changing Patch-
es while notes are being held.
If the following values are di erent between the Patches, there
will be a brief interruption:
Organ Type
Extra Voice
Multi-E ects
Octave
Manual Bass
Key Range
The MIDI velocity can not control by playing velocity.
e Sounding Point is set at AUTO.
Set the Sounding Point at DEEP. (P. 79)
The MENU/EXIT or RECORD buttons do not function.
e Display Lock is enabled.
Disable the Display Lock (P. 70).
The OCTAVE buttons do not function.
A function is assigned to the button.
Set the assign at ORIGIN. (P. 78).
To Next Page
Loading...
