Hammond SKX - Add Effects to the Organ Section; Vibrato & Chorus; Leslie; Overdrive

29
Getting Ready To Play
ADD EFFECTS TO THE ORGAN SECTION
VIBRATO & CHORUS
Adding a richness to the sound by changing pitch slightly with periodically.
[UPPER], [LOWER] buttons
Switches the Vibrato & Chorus e ect ON/OFF. When “ON” the light illuminates.
NOTE: You can adjust the Vibrato & Chorus e ect to your liking. (P. 81)
For this example, switch ON the [UPPER] button.
LESLIE
 e LESLIE e ect is the famous “Moving and Swirling” sound provided by rotating
horns and speakers, but executed here in the Digital realm.
[FAST] button
 is button toggles the mode of the Rotor to fast or not. When the light is “ON”, it
is FAST, and when “OFF”, not.
[STOP] button
 is button sets the mode when the [FAST] button is o . When the light is “ON”, it
is STOP, and when “OFF”, it is SLOW.
[BYPASS] button
To engage the Leslie e ect, press the [BYPASS] button turning the light “OFF”.
NOTE: These controls perform the same functions when a Physical Leslie is connected via the
11 pin socket.
NOTE: You can  ne-tune the parameters of the Digital Leslie e ect etc. (P. 82)
For this example, let’s set the status of all lights “OFF”.
OVERDRIVE
 e Overdrive section adds warmth at low settings, and “grit” or distortion at higher.
[ON] button
Toggles the Overdrive “OFF” and “ON” (when on the light is illuminated).
[AMOUNT] knob
Adjusts the amount of Overdrive.  e amount increases as you rotate the knob clock-
wise.
In this example, the Overdrive is not used.  e Button light should be “OFF”.
MULTI-EFFECTS
Adjusts the amount of the selected Multi-e ect to be applied to the Organ section.
 e default settings: at “Tremolo”.
[ON] button
Toggles the Multi-E ects “OFF” and “ON” (when on the light is illuminated).
[AMOUNT] knob
Adjusts the amount of Multi-E ect to be applied.  e amount increases as you rotate
the knob clockwise.
In this example, the Multi-E ects are not used.  e Button light should be “OFF”.