99
Setting the Parameters
REVERB
In this mode, you set the Reverb e ect.
Reverb is common with the Organ and Extra Voice sections, the single reverb control
section a ects both.
To locate this mode:
❶ DEPTH
is sets the depth (volume) of the Reverb E ect.
e setting range is 0 to 127. is parameter is linked with the [REVERB DEPTH]
knob on the top panel.
❷ TYPE
is sets the types of Reverb E ect.
Room 1: Small room
Room 2: Large room
Live: Ambient room
Hall 1: Large Hall
Hall 2: Small Hall
Church: Church
Plate: Iron-plate Reverb
Spring: Spring Reverb
Delay: Delay
PanDly: Panning Delay
RevDly: Reverb + Delay
❸ REVERB TIME
When the Type (#2) is set at Room 1 to Spring, e decay of the Reverb is attenu-
ated.
e setting range is 0 to 127. e decay becomes greater as the value is increased.
❹ DELAY TIME
When the Type (#2) is set at Delay, PanDly, RevDly, this sets the delay time.
e setting range is 4.7 to 2000ms. e delay becomes longer as the number value
is increased.
NOTE: You can set the delay time with the foot switch. (P. 76 #2)
❺ DELAY FEEDBACK
When the Type (#2) is at Delay, PanDly, RevDly, it sets the amount of Feedback
(How many times the sound repeats.)
e setting range is 0 to 96%. e repetition becomes greater as the value is in-
creased.
NOTE: Type (#2) is a micro-parameter. When you change the type, each reverb parameter
(except #1) is automatically set to the recommend value.
or, keep pressing the [REVERB ON] button for a few seconds.
See “Function mode” (P. 66) for operation details.
MENU/
EXIT
ENTER
NOTE: All the parameters in these modes are
Patch Parameters. They are recorded
into the Patch.
❶
❷
❸
❹
❺
To Next Page
Loading...
Need help?
General
