Skx
Owner’s Manual
22
HOW TO POWER ON
After making the necessary connections, follow the procedures below for powering on
your SKX. Please be sure to adhere to the procedure, to prevent malfunction or damage.
PROCEDURES
1. Before turning the power ON, con rm the [MASTER VOLUME] knob is set to
minimum.
2. Turn the [POWER] (on the rear of SKX) to the “ON”. e Title mode and then the
Play mode are displayed (as illustrated).
NOTE: For protecting the circuits, the SKX is designed not to play immediately at the power on
(about 6 seconds).
3. Turn the power to the connected ampli er etc. “ON”.
4. Play a bit, raising the [MASTER VOLUME] knob to adjust the volume to your
needs.
NOTE: The [MANUAL] button does not sound in the default settings. Pull out the Drawbars or
select any of the FAVORITE [1] to [10] buttons to get sound.
5. Adjust the volume of ampli er etc.
NOTE: To turn “OFF” the power, do the above steps in reverse. (Turn “OFF” the ampli er etc. rst.)
BACK UP
e SKX “remembers” the unit’s status immediately before the power is turned o ,
returning the unit to that status upon the next power-on.
e status of the default settings are the same as when the Favorite button [1] is
depressed.
AUTO POWER OFF
e SKX has an “AUTO POWER OFF” feature which will automatically turn the
power on the SKX “OFF” if no keys or buttons are pressed for 30 minutes.
To enable or disable the AUTO POWER OFF function, see “SYSTEM” P. 102.
NOTE: Depending on the status of SKX, while editing, for example, the power may not
turn o , even if the set time of AUTO POWER OFF elapses. So make sure to turn the
“POWER” switch OFF manually, after every use.
RESET TO THE FACTORY SETTINGS
To reset all parameters of SKX to its default settings, do the following:
OPERATION PROCEDURES
1. Switch the [POWER] of SKX o .
2. Holding down the [RECORD] button, switch the [POWER] ON.
3. Keep holding down the button until “Loading Default...” is displayed.
4. When the Play mode is displayed, this operation is completed.
SWITCH ON
UPPER
PEDAL
LOWER
NUMBER NAME
PATCH
To Next Page
Loading...
Need help?
General
