83
Setting the Parameters
❺ SLOW SPEED - HORN (L)
⓬ SLOW SPEED - BASS (L)
Sets the speed of the Rotors in Slow mode.
e setting range is 0, 24 to 318 rpm. At 0, no rotation.
❻ FAST SPEED - HORN (L)
⓭ FAST SPEED - BASS (L)
Sets the speed of the Rotors in the Fast mode.
e setting range is 0, 375 to 453 rpm. At 0, no rotation.
❼ HORN LEVEL (L)
⓮ BASS LEVEL (L)
Sets the volume of the Rotors, Horn and Bass. e setting range is 0 to -12dB.
❽ RISE TIME - HORN (L)
⓯ RISE TIME - BASS (L)
Sets the time for the Rotors to “ramp up” to the “Fast” speed, when switching either
from “Slow” or “Stop” mode.
e setting range for the Horn Rotor is 0.2 to 5.0sec., and the Bass Rotor is 0.5 to
12.5sec.
❾ FALL TIME - HORN (L)
⓰ FALL TIME - BASS (L)
Sets the time for the Rotors to “coast down” to “Slow” speed, when switching from
“Fast” mode.
e setting range for the Horn Rotor is 0.2 to 5.0sec., and that for the Bass Rotor is
0.5 to 12.5sec.
❿ BRAKE TIME - HORN (L)
⓱ BRAKE TIME - BASS (L)
Sets the time for the Rotors to come to a complete “Stop” when switching from
“Fast” mode.
e setting range for the Horn Rotor is 0.2 to 5.0sec., and the Bass Rotor is 0.5 to
12.5sec.
⓫ HORN CHARACTER (L)
Sets the tone of the Horn Rotor.
“FLAT” has no boost or cut in frequencies, and the “MID” or “DEEP” have “peaks”
in various tonal ranges, to mimic the particular characteristics of the horns.
⓲ MIC - ANGLE (L)
e ANGLE and DISTANCE recreates the e ect of two microphones.
e ANGLE sets the distance between the two virtual microphones.
e setting range is 0 to 180°. It is monaural at 0°, or both microphone placed in the
center. Each higher number has e ect of moving the microphones further apart from
each other, resulting in greater stereo separation.
⓳ MIC - DISTANCE (L)
Sets the e ect of setting the microphones at di erent distances from a Leslie Speaker
cabinet, since distance has an e ect on how the Leslie Speaker reproduces through a
sound system.
e setting range is 0.3 to 2.7m (metric measurements). Setting the range “further
away” will result in a less intense sound.
NOTE: After editing, you must record your changes to save them (Procedure following).
Rotor
Speed:
Rise
Time
Fall
Time
Brake
Time
Mode:
SLOW FAST SLOW FAST STOP
Distance
Angle
To Next Page
Loading...
