Hioki 3159 - Page 145

133
_____________________________________________________________________________________________
9.4 Command
______________________________________________________________________________________________
Syntax
:INS:RUPP <data>
<data>
OFF/ON
Response
syntax
OK
Insulation resistance test upper-limit value ON/OFF settings completion
Function
Enables and disables the upper-limit value for insulation resistance tests, in the READY state.
Example
Enables the upper-limit value for an insulation resistance test.
Transmission :INS:RUPP OFF
The insulation resistance upper-limit value enablement is OFF.
Response OK
Settings completion
Error
The execution of this command in a state other than the READY state causes an execution error.
Note that an execution error occurs when setting the test upper limit to on when the test lower
limit is greater than the test upper limit.
Syntax
:INS:RUPP?
Response
syntax
<data>
<data>
OFF/ON
Function
Queries the upper-limit value enablement for insulation resistance tests.
Example
Queries the upper-limit value enablement for insulation resistance tests.
Transmission :INS:RUPP?
Queries the upper-limit value enablement for insulation resistance tests.
Response OFF
The upper-limit value enablement is OFF.
Syntax
:INS:TIM <data>
<data>
OFF/ON
Response
syntax
OK
Insulation resistance test time enablement settings completion
Function
Enables and disables the test time for insulation resistance tests, in the READY state.
Example
Enables the test time for an insulation resistance test.
Transmission :INS:TIM ON
The insulation resistance test time enablement is ON.
Response OK
Settings completion
Error
The execution of this command in state other than the READY state causes an execution error.
:INS:RUPP
Enables and disables the upper-limit value for insulation resistance tests.
:INS:RUPP?
Queries the upper-limit value enablement for insulation resistance tests.
:INS:TIM
Enables and disables the test time for insulation resistance tests.