Hioki 3159 - Page 146

134
_____________________________________________________________________________________________
9.4 Command
______________________________________________________________________________________________
Syntax
:INS:TIM?
Response
syntax
<data>
<data>
OFF/ON
Function
Queries the test time enablement for insulation resistance tests.
Example
Queries the test time enablement for insulation resistance tests.
Transmission :INS:TIM?
Queries the test time enablement for insulation resistance tests.
Response ON
The test time enablement is ON.
Syntax
:CONF:WITH:VREF <data>
<data>
0.00 to 5.00 (NR2)
Response
syntax
OK
Function
Sets the comparative-voltage value for withstand voltage tests, in the READY state.
Example
Sets the comparative-voltage value for withstand voltage tests.
Transmission :CONF:WITH:VREF 1.50
The comparative-voltage value is set to 1.50 kV.
Response OK
Settings completion
Error
The execution of this command in a state other than the READY state causes an execution error.
Syntax
:CONF:WITH:VREF?
Response
syntax
<data>
<data>
0.00 to 5.00 (NR2)
Function
Queries the comparative-voltage value for withstand voltage tests.
Example
Queries the comparative-voltage value for withstand voltage tests.
Transmission :CONF:WITH:VREF?
Queries the comparativevoltage value.
Response 1.50
The comparative-voltage value is 1.50 kV.
:INS:TIM?
Queries the test time enablement for insulation resistance tests.
:CONF:WITH:VREF
Sets the comparative-voltage value for withstand voltage tests.
:CONF:WITH:VREF?
Queries the comparative-voltage value for withstand voltage tests.