Hioki 3159 - Page 151

139
_____________________________________________________________________________________________
9.4 Command
______________________________________________________________________________________________
Syntax
:CONF:INS:RUPP?
Response
syntax
<data>
<data>
0.20 to 2000 (NR1 or NR2)
Function
Queries the upper-limit value for insulation resistance tests.
Example
Queries the upper-limit value for insulation resistance tests.
Transmission :CONF:INS:RUPP?
Queries the insulation resistance upper-limit value.
Response 2000
The upper-limit value is 2000 MΩ.
Syntax
:CONF:INS:RLOW <data>
<data>
0.20 to 2000 (NR1 or NR2)
Response
syntax
OK
Function
Sets the lower-limit value for insulation resistance tests, in the READY state.
Example
Sets the lower-limit value for insulation resistance tests.
Transmission :CONF:INS:RLOW 10.0
The insulation resistance test lower-limit value is set to 10.0 MΩ.
Response OK
Settings completion
Error
The execution of this command in a state other than the READY state causes an execution error.
Note that an execution error occurs when setting the test lower limit to a value more than the test
upper limit when the latter is on.
Syntax
:CONF:INS:RLOW?
Response
syntax
<data>
<data>
0.20 to 2000 (NR1 or NR2)
Function
Queries the lower-limit value for insulation resistance tests.
Example
Queries the lower-limit value for insulation resistance tests.
Transmission :CONF:INS:RLOW?
Queries the insulation resistance lower-limit value.
Response 10.0
The lower-limit value is 10.0 MΩ.
:CONF:INS:RUPP?
Queries the upper-limit value for insulation resistance tests.
:CONF:INS:RLOW
Sets the lower-limit value for insulation resistance tests.
:CONF:INS:RLOW?
Queries the lower-limit value for insulation resistance tests.