Hioki 3159 - Page 158

146
_____________________________________________________________________________________________
9.4 Command
______________________________________________________________________________________________
Syntax
:MEM:WITH:FILE?
Response
syntax
Comparative-voltage value
0.00 to 5.00 (NR2) Upper limit value 0.1 to 120 (NR1 or NR2)
Lower limit value 0.1 to 119 (NR1 or NR2)
Test time setting value 0.5 to 999 (NR1 or NR2)
Output voltage range 2.5 or 5.0
When each setting is set to off, "0" will be returned.
<data>
1 to 10 (NR1)
Function
Queries the content of saved data for the withstand voltage test file numbers specified in <data>.
Example
Queries the data saved for withstand voltage tests.
Transmission :MEM:WITH:FILE? 1
Queries the Memory File 1 Settingsfor withstand voltage tests.
Response 1.20,5.0,0,20.0,2.5
Comparative voltage value: 1.20 kV; Upper-limit value: 5.0 mA;
Lower-limit value: OFF; Test time:20.0 s; Output voltage range: 2.5 kV
Error
The execution of this command in a state other than the READY state causes an execution error.
An execution error occurs when file numbers other than 1 to 10 are specified.
Syntax
:MEM:WITH:LOAD <data>
<data>
1 to 10 (NR1)
Response
syntax
OK
Output voltage range: 2.5 kV (NR2)
Function
Loads the data saved for the withstand voltage test file numbers specified in <data>.
Example
Loads withstand voltage tests saved data.
Transmission :MEM:WITH:LOAD 1
Loads the withstand voltage test Memory File 1.
Response OK
Loading completion
Error
The execution of this command in a state other than the READY state causes an execution error.
An execution error occurs when file numbers other than 1 to 10 are specified.
:MEM:WITH:FILE?
Queries the content of data saved for withstand voltage tests.
:MEM:WITH:LOAD
Loads withstand voltage tests saved data.