Hitachi P-N23NA2 Service Manual

9 Servicing
RCD-(0.8-6.0)FSN3 - 2-way cassette
SMGB0099 rev.0 - 12/2016
268
9.3 RCD-(0.8-6.0)FSN3 - 2-way cassette
9.3.1 Removal of the Air lter and the Air inlet grille
? NOTE
The Air lter is located inside the air inlet grille.
1 Lift up one side of the air inlet at grille then slide to arrow
direction. Pull the air inlet at grille to the downward.
Air intake grille
2 Turn all the knobs 90° then remove the air lter. (6
knobs for RCD-0.8 to 3.0FSN3, 10 points for RCD-4.0 to
6.0FSN3).
3 Remove the chain from the air panel.
4 Open the air inlet at grille at an approximately 40º angle
from the air panel surface. Tilting the air inlet at grille, lift
it up to draw forward then remove it.
? NOTE
The air inlet at grille can be opened up to 90°. However, it cannot
be removed from the air panel at that angle.
Air inlet grille
Air lter
Knob
Knob
Chain
Turn 90º
9.3.2 Removal of the electrical box
? NOTE
The Electrical box appears when opening the air inlet grille.
1 Open the air inlet grille.
2 Loosen the screw securing the electrical box cover. The electrical box cover does not need to be removed but keep
hooked for maintenance work.
RCD-(0.8-3.0)FSN3 RCD-(4.0-6.0)FSN3
Screw
・
・@
・ｮ
・ｻ・@・ﾔ
Electrical box
Electrical box
cover
Hinge / Hook
Screw
Screw
Fan control
Electrical box cover
Fan control
Electrical box
Electrical box cover
! CAUTION
Pay attention during the removing work as the Electrical box may fall.

Hitachi P-N23NA2 Specifications

General

Brand	Hitachi
Model	P-N23NA2
Category	Air Conditioner
Language	English