Hitachi WJ200 Series

C−10
“A” Function
Run
Mode
Edit
Defaults
Func.
Code
Name Description Lnitial data Units
a151
Curvature of EL-S-curve at
the end of acceleration
Range is 0 to 50%
U
10. %
a152
Curvature of EL-S-curve at
the start of deceleration
Range is 0 to 50%
U
10. %
a153
Curvature of EL-S-curve at
the end of deceleration
Range is 0 to 50%
U
10. %
a154
Deceleration hold frequency Sets the frequency to hold
deceleration, range is 0.0 to
400.0Hz
U
0.0 Hz
a155
Deceleration hold time Sets the duration of
deceleration hold, range is 0.0
to 60.0 seconds
U
0.0 sec.
a156
PID sleep function action
threshold
Sets the threshold for the
action, set range 0.0~400.0 Hz
U
0.00 Hz
a157
PID sleep function action
delay time
Sets the delay time for the
action, set range 0.0~25.5 sec
U
0.0 sec
A161
[VR] input active range start
frequency
The output frequency
corresponding to the analog
input range starting point,
range is 0.0 to 400.0 Hz
U
0.00 Hz
A162
[VR] input active range end
frequency
The output frequency
corresponding to the current
input range ending point,
range is 0.0 to 400.0 Hz
U
0.00 Hz
A163
[VR] input active range
start %
The starting point (offset) for
the current input range,
range is 0. to 100.%
U
0. %
A164
[VR] input active range
end %
The ending point (offset) for the
current input range,
range is 0. to 100.%
U
100. %
A165
[VR] input start frequency
select
Two options; select codes:
00…Use offset (A161 value)
01…Use 0Hz
U
01
−