Hitachi WJ200 Series - Page 398

C−17
“b” Function
Run
Mode
Edit
Defaults
Func.
Code
Name Description Lnitial data Units
B092
Cooling fan control Selects when the fan is ON during
inverter operation, four options:
00…Fan is always ON
01…Fan is ON during run, OFF
during stop (5 minute delay
from ON to OFF)
02…Fan is temperature controlled
U
01 -
B093
Clear elapsed time of cooling
fan
Two option codes:
00…Count
01…Clear
U
00 -
b094
Initialization target data Select initialized parameters, four
option codes:
00…All parameters
01…All parameters except
in/output terminals and
communication.
02…Only registered parameters in
Uxxx.
03…All parameters except
registered parameters in Uxxx
and b037.
U
00 -
b095
Dynamic braking control
(BRD) selection
Three option codes:
00…Disable
01…Enable during run only
02…Enable always
U
01 -
b096
BRD activation level Range is:
330 to 380V (200V class)
660 to 760V (400V class)
U
360/
720
V
B100
Free V/F setting, freq.1 Set range, 0 ~ value of b102
U
0. Hz
b101
Free V/F setting, voltage.1 Set range, 0 ~ 800V
U
0.0 V
b102
Free V/F setting, freq.2 Set range, value of b100 ~b104
U
0. Hz
b103
Free V/F setting, voltage.2 Set range, 0 ~ 800V
U
0.0 V
b104
Free V/F setting, freq.3 Set range, value of b102 ~b106
U
0. Hz
b105
Free V/F setting, voltage.3 Set range, 0 ~ 800V
U
0.0 V
b106
Free V/F setting, freq.4 Set range, value of b104 ~b108
U
0. Hz
b107
Free V/F setting, voltage.4 Set range, 0 ~ 800V
U
0.0 V
b108
Free V/F setting, freq.5 Set range, value of b108 ~b110
U
0. Hz
b109
Free V/F setting, voltage.5 Set range, 0 ~ 800V
U
0.0 V
b110
Free V/F setting, freq.6 Set range, value of b108 ~b112
U
0. Hz
b111
Free V/F setting, voltage.6 Set range, 0 ~ 800V
U
0.0 V
b112
Free V/F setting, freq.7 Set range, b110 ~ 400
U
0. Hz
b113
Free V/F setting, voltage.7 Set range, 0 ~ 800V
U
0.0 V