Hitachi WJ200 Series

2−27
d001
V U
ESC
SET
Group "d"
Func. code display
0.00
d002
d104
F001
V U
Group "F"
Func. code display
F002
F004
50.00
50.01
SET
SET
ESC
SET
ESC
Save
Data display (F001 to F003)
Data does not blink because of real time synchronizing
: Saves the data in EEPROM and returns to func. code display.
: Returns to func. code display without saving data.
SET
ESC
A001
V U
ESC
Func. code display
: Jumps to the next group
ESC
SET
ESC
: Moves to data display
Func. code display
Group "A"
Func. code display
A002
Group "b"
b001
ESC
Group "C"
C001
ESC
Group "H"
H001
ESC
Group "P"
P001
ESC
Group "U"
U001
ESC
A165
ESC
SET
SET
01
SET
Data display
When data is changed, the display starts blinking, which means that
new data has not been activated yet.
ESC
SET
: Cancels the data change and returns to func. code display.
: Saves the data in EEPROM and returns to func. code display.
ESC
00
Refer to 2-34 for further information.
Press the both up and down key at the same
time in func. code or data display, then
single-digit edit mode will be enabled.
V
U
NOTE: Pressing the [ESC] key will make the display go to the top of next function
group, regardless the display contents. (e.g. A021 Æ [ESC] Æ b001)